Over voltages or surge voltages

Discussions related to engineering and its applications. From civil and mechanical to aeronautic and robotics, etc.

Over voltages or surge voltages

Postby jituchnfd4321 on February 22nd, 2019, 1:24 am 

How to protect the power supply against over voltages or surge voltages?
jituchnfd4321
Forum Neophyte
 
Posts: 2
Joined: 22 Feb 2019


Re: Over voltages or surge voltages

Postby Dave_Oblad on February 24th, 2019, 2:49 am 

Hello jituchnfd4321,

Google Varistors, Transorbs and general Surge Protection Devices and Schemes.

https://en.wikipedia.org/wiki/Varistor
https://en.wikipedia.org/wiki/Transient-voltage-suppression_diode
https://en.wikipedia.org/wiki/Electrical_reactance

There is not enough information provided above to give a singular cost effective answer.

There are many methods depending on the nature, energy and frequency aspects in protecting a power supply.

Devices across the power source input can limit the maximum voltage input using an avalanche device that appears nearly invisible until a specific voltage threshold is exceeded.. at which time the device becomes a short circuit to any voltage exceeding its rating. This clamps the input voltage but can over heat if the frequency of voltage spikes exceeds the current ratings of said device long enough.

Likewise, a coil(s) in series with the supply can block high frequency spikes from passing through said coils. As a spike hits the coil, it causes an increase in current flow, this creates a growing magnetic field, the growth of said field creates an inverse current/voltage back flush that cancels the incoming spike.

Hope this helps.

Good luck,
Dave :^)
User avatar
Dave_Oblad
Resident Member
 
Posts: 3228
Joined: 08 Sep 2010
Location: Tucson, Arizona
Blog: View Blog (2)


Re: Over voltages or surge voltages

Postby jituchnfd4321 on February 27th, 2019, 1:38 am 

Thank you for this guidance..
https://crbtech.in/online-electrical-design-training-course
jituchnfd4321
Forum Neophyte
 
Posts: 2
Joined: 22 Feb 2019



Return to Engineering & Electronics

Who is online

Users browsing this forum: No registered users and 3 guests